Every now and then CPAP users have the same problem. It is more common than you may believe and it happens to experienced users also. The problem is when a user replaces the CPAP mask. It should fit nicely to the old hose and the CPAP machine afterward. The problem is when you cannot make this connection. Obviously, you cannot use the machine, you cannot use CPAP Cleaner Ozone Sterilizer Disinfector Sanitizer and you need to solve the problem as quickly as possible. Luckily there is a simple solution for all of that. It will be revealed in the content below.
Most Common Issue And How to Fix it
The most common issue is actually with the swivel piece or connector that is stuck in the old hose. Once that happens, you won’t be able to attach a new mask to the old hose because it already has a separate swivel connector installed.
The solution is to pull out the swivel connector. Some users had to use pliers to get this job done. You are less-likely to encounter the same problem but be prepared for anything. Once done, simply connect a new mask to the old hose and connect it to the machine. Now you can use the CPAP Cleaner Ozone Sterilizer Disinfector Sanitizer. In addition, replacing the hose every 6 months or less is important in order to prevent this issue from happening again.
AirFit P10 won’t Connect to the Dream Station Machine Hose
This is another, although less common issue. The tube or the cuff of it is 22mm while the tube itself is 15mm. What this means is that it is universal and it can be connected to a new CPAP machine. The problem is in the 1inch cylinder that is stuck in the hose. It comes from the elbow of the CPAP mask.
Pull it out using your fingers if possible and you will connect the components successfully. It may be deep into the tube, so take your time and try to complete the task without damaging hose.
Climtate line won’t fit the Respironics Dreamwear CPAP Mask
This is a rare issue and it happens with some patients. Basically, they cannot connect these two. The solution was to remove a small part of the swivel after which connection will be possible.
However, the real solution is to use an adapter. In most cases, it will be included in the box and you can only install it. But, if it isn’t included, you will need to get one additionally.
We must add that a swivel piece that comes with a new mask is very important, as you were able to see. If you lose it, in some cases you can find a new piece separately. But, some manufacturers don’t offer this benefit. If that happens, you will need to get a new mask or try to look for compatible swivel made by third-party manufacturers.
F10 Mask Connection With the Non-Heating Hose
First of all, this is possible. You will need to connect the short tube with the end of the heated hose. It is a simple connection but if it isn’t possible, the connector is stuck in the elbow assembly from the mask is located in the hose. Remove it and try to connect the units again.
Conclusion
As you were able to see the most common issue is the fact that a mask swivel connector is stuck in the hose. When you remove it, you will be able to attach a new mask without any fuss. After that, you can use the CPAP machine and you can use CPAP Cleaner Ozone Sterilizer Disinfector Sanitizer to make sure your system is 100% clean and effective. Take your time and try to solve a problem without damaging the components.
My Prime Clean 